Error Code - Muratec MFX-2500 Field Engineering Manual

7. At the end of this operation (it takes a few minutes), the Flash ROM writer indicates the Check Sums of
the last ROMs.
8. Pressing the SW1, confirm the Check Sums as follows:
Check Sum of ROM0, Check Sum of ROM1
Check Sum of ROM2, Check Sum of ROM3
Check Sum of ROM4(CGROM0), Check Sum of ROM5(CGROM1)
If the Check Sum indicated on the Flash ROM writer and the one written on the ROM are not same,
confirm the cable connection and the ROM attaching, then perform from step 1 again.
9. Turn off the power switch, then disconnect the cables.
10. (Re-attach the rear cover using the three screws.)

Error code

If the error occurred during writing, the following error code will be appeared:
E.02: Maker code read error
E.04: Sector erase error
E.05: Writing error
E.06: Sum check error
E.07: Time out error
When the above error occurred, turn off the power switch, confirm the cable connection and the ROM
attaching, then perform from step 1 again.
(Pressing SW1)
(Pressing SW1)
3-143
(Pressing SW1)