All Ram Clear; Setting Individual Autodialer Attributes - Muratec MFX-2500 Field Engineering Manual

3.5 All RAM Clear

The All RAM Clear setting will erase all user programmed information, all documents in memory, and reset
the memory switches and machine parameters to factory defaults.
This feature may also be used to try and clear a machine malfunction or lock up. If possible, when the All
RAM Clear is used to reset a malfunction or lock up, it is advisable to print the machine settings, one-
touch and speed dial listings to help in reprogramming this information.
Note: The All RAM Clear does not clear the machine parameters, life monitor and consumable order
sheet. If you need to clear them, see "Clearing the machine parameters," page 3-2 or "Clear Life
Monitor," page 3-140.
1. To perform an All RAM Clear, from standby, press MENU, *, 3.
2. Press [Enter].
Note: To finish the operation without performing RAM clear, press [Cancel].

3.6 Setting Individual Autodialer Attributes

This function allows the user to configure an individual one-touch or speed dial entry with the settings
shown in Memory Switches B:0, B:1, B:2 and B:3.
To set the individual attributes:
1. Change memory switch B:5, bit 7 to a "1". (See setting 3.3.1 Setting the Memory Switches for more
information on changing memory switch B:5.)
2. When the function is enabled, an "Attribute" option is added to the autodialer programming steps. As a
one-touch or speed dial location is programmed, an extra step showing Attribute 1, Attribute 2, Attribute
3, and Attribute 4 are added as the last step.
3. Set the individual bit positions as shown in the following table. To change a setting, press
the cursor key until the cursor is below the desired bit position; then press "1" or "0" to make the
change.
4. Press [Enter] to save the setting and advance to the next attribute.
5. To set the other attribute, repeat steps 3-4.
3-97
or of