If You Cannot Make Clear Copies - Muratec MFX-2500 Operating Instructions Manual

Trouble shooting
Symptom Check for/What to do
The machine is not The power cord is left unplugged from the power outlet.
activated when the Plug the power cord into the power outlet.
power switch is turned
ON.
Misfeeds occur Paper size setting is incorrect.
frequently. Set the correct paper size.
Some of the selected Selected functions cannot be combined.
functions are Check the combination of functions. (See "Combination
unavailable. chart," page
In EraseBorder or Margin is too wide. Or, margin of your document is too
EraseCenter mode, narrow.
parts of the original Set the narrower margin.
image are not copied.
In Combine mode, Your set originals are not identical in size and direction.
parts of the image are It is impossible to combine originals as they are not
not copied or parts identical in size and direction. Copy these originals with
of the copy paper are the same size paper, set copies which are identical in size
blank. and direction, and then select Combine.
In Combine mode, Your originals are set in incorrect order.
order of copies is not When you set a stack of originals in the ADF, the first page
correct. must be on top.
When you set an original on the FBS glass, start with the
first page to be copied.
In Duplex copy mode, Your originals are set in incorrect order.
order of copies is not When you set a stack of originals in the ADF, the first page
correct. must be on top.
When you set an original on the FBS glass, start with the
first page to be copied.
4.2
.1)
AI

If you cannot make clear copies

Symptom Possible cause/What to do
The image is too light. The image contrast is too light.
Adjust the image contrast by pressing
. . . or . . .
The toner is low.
Replace the toner bottle.
. . . or . . .
The paper is damp.
Change the paper.
The image is too dark. The image contrast is too dark.
Adjust the image contrast by pressing
. . . or . . .
The FBS glass surface is dirty.
Wipe the FBS glass clean with a soft dry cloth.
The copy is blurry. The paper is damp.
Change the paper.
The copy has lines. The FBS glass surface is dirty.
or Wipe the FBS glass clean with a soft dry cloth.
The copy has dark . . . or . . .
specks or spots. The FBS pad is dirty.
Wipe the FBS pad clean with a soft cloth dampened with
alcohol.
. . . or . . .
The original your document is very thin or highly trans-
parent.
Place a blank sheet of paper over the original.
. . . or . . .
The original your document is 2-sided.
The information on the back side of a 2-sided, thin origi-
nal may be slightly reproduced on the copy. Adjust the
image contrast level lighter by pressing
key.
CONTRAST
key.
CONTRAST
key.
CONTRAST