All Ram Clear; Setting Individual Autodialer Attributes - Muratec F-315 Field Engineering Manual

3.5 All RAM Clear

The All RAM Clear setting will erase all user programmed information, all documents in memory, and reset
the memory switches to factory defaults.
This feature may also be used to try and clear a machine malfunction or lock up. If possible, when the All
RAM Clear is used to reset a malfunction or lock up, it is advisable to print the machine settings, one–
touch and speed dial listings to help in reprogramming this information.
Note: The All RAM Clear does not clear the machine parameters, life monitor and consumable order
sheet. If you need to clear them, see "Clearing the machine parameters," page 3-3 or "Clear Life
Monitor," page 3-141.
1. To perform an All RAM Clear, from standby, press <Menu>, <*>, <0>, <3>.
All RAM Clear
Yes → Enter
2. Press <Enter>.
Note: To finish the operation without performing RAM clear, press <Cancel>.

3.6 Setting Individual Autodialer Attributes

This function allows the user to configure an individual one–touch or speed dial entry with the settings
shown in Memory Switches 10, 11, 12 and 13.
To set the individual attributes:
1. Change memory switch 15, bit 7 to "1". (See setting 3.3.1 Setting the Memory Switches for more
information on changing memory switch 15.)
2. When the function is enabled, an "Attribute" option is added to the autodialer programming steps. As a
one-touch or speed dial location is programmed, an extra step showing Attribute 1, Attribute 2, Attribute
3, and Attribute 4 are added as the last step.
01:Attribute1
Bit No. 76543210
3. Set the individual bit positions as shown in the following table. To change a setting, press <
until the cursor is below the desired bit position; then press <1> or <0> to make the change.
4. Press <Enter> to save the setting of the displayed attribute and advance to the next attribute.
5. To set other attributes, repeat steps 3-4.
6. When the last attribute is set, the fax will advance to the next autodialer programming steps.
10001101
3-84
> or < >