Configuring Bpdu Transparent Transmission; Configuring Destination Multicast Mac Address For Bpdu Tunnel Frames; Bpdu Tunneling Configuration Example - HP 4800G Series Configuration Manual

Configuring BPDU Transparent Transmission

Perform the following tasks to configure BPDU transparent transmission:
To do...
Enter system view
Enter Ethernet or
Layer-2 aggregate
interface view
Enter
interface
view or port
Enter port group
group view
view
Disable STP on the port(s)
Enable BPDU tunneling for STP
on the port(s)
Configuring Destination Multicast MAC Address for BPDU Tunnel
Frames
By default, the destination multicast MAC address for BPDU tunnel frames is 0x010F-E200-0003. You
can modify it to 0x0100-0CCD-CDD0, 0x0100-0CCD-CDD1 or 0x0100-0CCD-CDD2 through the
following configuration.
Follow these steps to configure destination multicast MAC address for BPDU tunnel frames:
To do...
Enter system view
Configure the destination multicast
MAC address for BPDU tunnel
frames
For BPDU tunnel frames to be recognized, the destination multicast MAC addresses configured for
BPDU tunneling must be the same on the edge devices on the service provider network.

BPDU Tunneling Configuration Example

Network requirements
Customer A and Customer B are customer network edge devices.
Use the command...
system-view
interface interface-type
interface-number
port-group manual
port-group-name
undo stp enable
bpdu-tunnel dot1q stp
Use the command...
system-view
bpdu-tunnel tunnel-dmac
mac-address
1-3
Remarks
—
Required
Use either command.
Settings made in interface view
take effect only on the current
port.
Settings made
aggregate interface view take
effect only on
aggregate interface.
Settings made in port group view
take effect on all ports in the port
group.
Required
Required
By default, BPDU tunneling for STP
is disabled.
Remarks
—
Optional
0x010F-E200-0003 by default.
in Layer-2
the Layer-2