HP 4800G Series Configuration Manual page 231

To do...
In system view
Configure
mirroring
ports
In interface
view
In system view
Configure
the egress
port
In interface
view
Configure the probe VLAN
When configuring the mirroring ports, note that:
The mirroring ports and the egress port must be located on the same device.
To ensure device performance, do not assign the mirroring ports to the remote probe VLAN.
When configuring the egress port, note that:
The port must not be a mirroring port in the mirroring group.
To ensure operation of the device, disable these functions on the port: STP, MSTP, RSTP, 802.1x,
IGMP Snooping, static ARP, and MAC address learning.
A remote port mirroring group can have only one egress port.
Use the command...
mirroring-group groupid
mirroring-port mirroring-port-list
{ both | inbound | outbound }
interface interface-type
interface-number
[ mirroring-group groupid ]
mirroring-port { both | inbound |
outbound }
quit
mirroring-group groupid
monitor-egress
monitor-egress-port-id
interface interface-type
interface-number
mirroring-group groupid
monitor-egress
quit
mirroring-group groupid
remote-probe vlan rprobe-vlan-id
1-5
Remarks
Required
You configure multiple
mirroring ports in a
mirroring group.
In system view, you can
assign a list of mirroring
ports to the mirroring
group at a time.
In interface view, you can
assign only the current
interface to the mirroring
group. To monitor multiple
ports, repeat the step.
Required
Use either approach.
Required