Configuring The Maximum Number Of Ospfv3 Load-Balanced Routes; Configuring A Priority For Ospfv3 - HP 3600 v2 series Configuration Manual

To do...
Enter system view
Enter interface view
Configure an OSPFv3 cost
for the interface
Follow these steps to configure a bandwidth reference value:
To do...
Enter system view
Enter OSPFv3 view
Configure a bandwidth reference
value
Configuring the maximum number of OSPFv3 load-balanced
routes
If multiple equal-cost routes to a destination are available, enabling load balancing among these routes
can improve link utilization.
Follow these steps to configure the maximum number of load-balanced routes:
To do...
Enter system view
Enter OSPFv3 view
Specify the maximum number of
load-balanced routes

Configuring a priority for OSPFv3

A router may run multiple routing protocols. The system assigns a priority for each protocol. When these
routing protocols find the same route, the route found by the protocol with the highest priority is selected.
Follow these steps to configure a priority for OSPFv3:
To do...
Enter system view
Enter OSPFv3 view
Configure a priority for
OSPFv3
Use the command...
system-view
interface interface-type
interface-number
ospfv3 cost value [ instance
instance-id ]
Use the command...
system-view
ospfv3 [ process-id ]
bandwidth-reference value
Use the command...
system-view
ospfv3 [ process-id ]
maximum load-balancing
maximum
Use the command...
system-view
ospfv3 [ process-id ]
preference [ ase ] [ route-policy
route-policy-name ] preference
288
Remarks
—
—
Optional
The default cost depends on the interface type:
1 for a VLAN interface; 0 for a loopback
interface; computed according to the
bandwidth for other interfaces.
Remarks
—
—
Optional
100 Mbps by default
Remarks
—
—
Optional
8 by default
Remarks
—
—
Optional
By default, the priority of OSPFv3 internal
routes is 10, and priority of OSPFv3
external routes is 150.