Introduction - Intermec Sabre 1552 Scanner System Manual

This chapter explains how to program the Cordless System to work with your terminal
or computer (host system).

Introduction

All operating parameters are stored in non-volatile memory resident in the Cordless
System, where they are permanently retained in the event of a power interruption. When
you receive your Cordless System, certain operating parameters have already been set.
These are the factory defaults, indicated by the symbol "*" on the programming pages
(beneath the default programming bar code). Default charts that list all the factory
default settings may be found in Chapter 8, "Specifications and Factory Defaults."
Appendix A, "Programming Chart and Sample Bar Codes," has a programming chart
that contains alphanumeric bar codes for setting additional programming options, such
as the digits representing Symbology Message Length. The programming chart explains
how and when to use the alphanumeric bar codes.
Note: After scanning these menu selections, you will notice a pause (up to 20 seconds)
while the base processes and uploads the new menu information to its parameter tables:
•
•
•
Appendix A also has a sample bar codes page that provides bar code symbols you may
scan to verify that your Cordless System has been programmed correctly and is
communicating with your host system.
Plug and Play Selections (on the next two pages)
Factory Default Settings: ALL Application Groups (Chapter 2)
Application Work Group Selections (Chapter 4)
Quick Start and Interface Menu
2
2-3