Hardware Flow Control Selection; Data Character Selection - Intermec Sabre 1552 Scanner System Manual

Hardware Flow Control Selection

This selection turns on hardware flow control that checks for a CTS signal before
sending data. This option is useful when your application supports the CTS signal.
On
*Off
Note: The auxiliary port receive function will only work properly if RTS/CTS or
ACK/NAK flow control is used. If your host system does not support RTS/CTS or
ACK/NAK handshaking, some or all of your data will be lost.

Data Character Selection

This selection selects the serial output data characters that may be sent from the RS-232
device connected to the auxiliary port.
•
•
•
•
SOR (Start of Record)
EOR (End of Record)
1
You will need to scan a two-digit number and Save after you scan this programming barcode. Refer to the "Programming
Chart" in Appendix A.
Default SOR Character = none (NUL: 00).
Default EOR Character = Carriage Return (CR: 0D).
Default SOB Character = none (NUL: 00).
Default EOB Character = End of Text (EOT: 04).
1
1
Communications Menu
3
3-13