Laser Marker Beam; Aim Id Prefix - Intermec Sabre 1552 Scanner System Manual

Sabre 1552 Scanner and MicroBar 9745 Base Station System Manual

Laser Marker Beam

When this selection is turned on (short or long duration), the scanner shows a marker or
locator beam before the red scan line opens across a bar code and the scanning process
begins. The marker beam, emitted by centering the optical scan mirror, appears as a
bright spot of illumination that serves as an aiming guide when bar code targets are at a
distance from the scanner.
Note: Laser Marker Beam works best for long range and high visibility units. If this
selection is turned on in standard products, the scan rate is diminished.
*Off
Short Duration (0.5 second)
Long Duration (1.2 seconds)

AIM ID Prefix

This selection allows you to turn on or off the transmission of an AIM ID before the
decoded symbology. (See the Symbology Chart on the next page for the single AIM
character code that identifies each symbology.) When you scan the On code, all current
prefixes are cleared, then an AIM ID for all symbologies is programmed.
On
*Off
4-8