Intermec Sabre 1552 Scanner System Manual page 135

Does the Cordless System read your bar code incorrectly?
If the Cordless System reads a bar code (one beep for a good read), but the bar code is
not displayed correctly on the host screen:
1. The Cordless System may not be programmed for the appropriate terminal
interface.
Example: You scan "12345" and the host displays "@es%."
Reprogram the Cordless System with the correct "Plug and Play" or Terminal
Selection bar code.
2. The Cordless System may not be programmed to output your bar code properly.
Example: You scan "12345" and the host displays "A12345B."
Reprogram the Cordless System with the proper Symbology selections.
The Cordless System won't read your bar code at all?
If the Cordless System will not read your bar code
•
Try scanning the sample bar codes in Appendix A.
If the Cordless System reads the sample bar codes, check that your bar code is
readable. (See "Is the Cordless System having trouble reading your bar codes?" on
the previous page.)
•
Verify that your bar code symbology is enabled.
If the Cordless System does not read the sample bar codes
•
Verify that the bar code symbologies are enabled.
•
Scan the "Default All..." bar code on each symbology menu page to enable most
symbologies.
Maintenance and Troubleshooting
7
7-7