Battery Pack; North American Charging Information; Worldwide Charging Information; Battery Pack Recommendations - Intermec Sabre 1552 Scanner System Manual

Battery Pack

Power is supplied to the scanner by a rechargeable
Nickel Metal Hydride (NiMH) battery pack that snaps
onto the bottom of the scanner.

North American Charging Information

The battery packs are designed to plug into any two
prong North American AC power outlet (110/120 Volt)
for direct charging. You need no additional equipment
and you can recharge the packs virtually anywhere. If
you want surge protection, a charge strip can provide extra protection.

Worldwide Charging Information

The NiMH battery pack is rated for both 110/120 Volt 60 Hz applications and for
230/240 Volt 50 Hz applications; therefore, it may be recharged worldwide. For
international charging and to accommodate the wide variety of electrical outlets, a
custom charge strip is required to charge the batteries. The charge strip is offered for
two or six battery pack configurations.
Contact your local Intermec representative for more information on charge strips.

Battery Pack Recommendations

•
Charge the battery for 24 hours the first two or more times to fully charge the
battery.
•
Charge the battery pack immediately before use or at least within a couple of days
of use.
•
Remove the battery pack from the power outlet after charging is completed. Avoid
extended overcharging; do not leave the battery charging for more than 2 days.
•
Periodically fully discharge the battery pack.
•
Avoid using the battery pack in extreme temperatures.
•
Do not disassemble the battery pack. There are no user-serviceable parts in the
battery pack.
1
Getting Started
1-5