Proper Disposal Of The Battery Pack; Charging The Battery Pack - Intermec Sabre 1552 Scanner System Manual

Sabre 1552 Scanner and MicroBar 9745 Base Station System Manual

Proper Disposal of the Battery Pack

When the battery pack has reached the end of its useful life, the batteries should be
disposed of by a qualified recycler or hazardous materials handler. Do not incinerate the
battery pack or dispose of the battery pack with general waste materials. Contact
technical support for recycling or disposal information.

Charging the Battery Pack

1. Fully charge the battery pack. If you
2. Note that the LED on the bottom of the
3. After the battery pack is fully charged, attach it to the scanner by pressing the pack
When the battery pack needs recharging, the yellow LED on top of the scanner pulses in
short, continuous blinks and the scanner won't beep when you pull the trigger. If the
LED stops flashing when the temperature lowers or you do not use the battery pack for
some time, you still need to charge the battery pack.
1-6
are in North America, plug the battery
pack directly into any common 120
Volt AC outlet.
If you are outside North America, use
a custom charge strip. Plug the battery
packs into the charge strip and plug the
charge strip into an outlet.
battery pack lights red when the
battery pack is charging; it shows
green when it is fully charged and
ready to use.
It is important that you charge the
battery for 24 hours prior to first use.
No damage occurs if this is not done, but the battery capacity will not be at 100%.
firmly (align the prongs on the pack with the mating receptacles) in the base of the
scanner until the release buttons click, holding the pack firmly in place. (When you
attach a charged battery pack to the scanner, you will hear a single beep.)
Cordless
scanner
Rechargeable
battery pack
1552S020.eps