Aux Suffix Enable/Disable; Aux Data Formatter Selections - Intermec Sabre 1552 Scanner System Manual

Sabre 1552 Scanner and MicroBar 9745 Base Station System Manual

Aux Suffix Enable/Disable

These codes are used when you want to toggle between turning on and off the suffix
formatting.
Enable Aux Suffix
Disable Aux Suffix

Aux Data Formatter Selections

The Aux Data Format Editor selections are used to edit incoming data to the auxiliary
port. For example, you can use the Aux Data Format Editor to insert characters at
certain points in bar code data as it is scanned.
It is not necessary to use the Aux Data Format Editor. A set of defaults for the auxiliary
data format is already programmed in the base. The selections in the following pages
are used only if you wish to alter the default settings.
•
If you have changed auxiliary data format settings, and wish to clear all formats and
return to the defaults, scan the Default Aux Data Format bar code.
To add an auxiliary data format
1. Scan the Enter Aux Data Format bar code.
2. Primary/Alternate Format
3-18
Default Aux Data Format setting = none.
Enter Aux Data Format
Determine if this will be your primary auxiliary data format, or if it will be one of
three alternate formats. (Alternate formats allow you "single shot" capability to scan
one bar code using a different auxiliary data format. After the one bar code has been
read, the scanner reverts to the primary auxiliary data format.) If you are
programming the primary format, scan 0. If you are programming an alternate
format, scan 1, 2, or 3, depending on the alternate format you are programming.