Recharging And Replacing The Battery Pack; Resetting Factory Settings - Intermec Sabre 1552 Scanner System Manual

Recharging and Replacing the Battery Pack

When the battery pack needs to be recharged, follow the instructions below to recharge
and replace the battery pack.
To recharge and replace the battery pack
1. Detach the battery pack from the
bottom of the scanner.
2. In North America, plug the
battery pack directly into any
common 120 Volt outlet.
For international charging and to
accommodate the wide variety of
electrical outlets, a custom charge
strip is required to charge the
batteries.
3. The LED on the bottom of the
battery pack is red when the unit
is charging; it is green when it is
fully charged and ready to use.
(See "Battery Specifications" in
Chapter 8 for charging time and expected hours of operation.)
4. After the battery pack is fully charged, attach to the scanner by pressing the pack
firmly (align the prongs on the pack with the mating receptacles) in the base of the
scanner until the release buttons click, holding the pack firmly in place.
5. If the scanner wasn't previously associated to a base, scan the Association Bar Code
on the top of the base. If the scanner was previously associated to a base, it will
automatically re-associate. (The association process takes about 10 seconds.)

Resetting Factory Settings

If you are unsure of the programming options that have been set up in your Cordless
System and you want the factory settings restored, scan the Factory Default Settings bar
code. For help, see "Reset Factory Settings" in Chapter 2.
Maintenance and Troubleshooting
Yellow
LED
1552S010.eps
7
Press release
buttons
(2 places)
7-5