Decode Beep Selection; Scanner Voting Selection - Intermec Sabre 1552 Scanner System Manual

Scanner and base station
Hide thumbs Also See for Sabre 1552 Scanner:
Table of Contents

Advertisement

4
Application Work Groups Menu

Decode Beep Selection

Note: Decode Beep mode is active only when the programming selections Host ACK or
Data Format Required are turned on.
When Host Ack Selection is on, the scanner will only beep/blink in response to the
Escape commands generated by the host. Should you also want the scanner to beep
when a bar code has been successfully decoded, turn on the Decode Beep Selection.
When Data Format Required is on, the scanner will only beep if the input data conforms
to the edited format or triple beep if it does not meet the format requirements. Should
you also want the scanner to beep when a bar code has been successfully read and sent
to the host from the base, turn on the Decode Beep Selection.
On
*Off

Scanner Voting Selection

When Scanner Voting is turned on, the Cordless System requires three identical,
consecutive scans before the bar code data will be accepted and transmitted to the
terminal. When this selection is turned off, the bar code data will be transmitted
following one valid scan. See the "Voting Table" in Chapter 8.
On
*Off
4-7

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Sabre 1552 Scanner and is the answer not in the manual?

This manual is also suitable for:

Microbar 9745

Table of Contents