Auxiliary Port Communications; Baud Rate Selection - Intermec Sabre 1552 Scanner System Manual

Sabre 1552 Scanner and MicroBar 9745 Base Station System Manual
Escape Commands (continued)
Command
Esc a
Esc b
Esc 1
Esc 2
Esc 3
Esc 4
Esc 5
Esc 6
Esc 7
Esc 8
Note: Host ACK may be used with Decode Beep Selection.

Auxiliary Port Communications

*Default All Auxiliary Port Communications

Baud Rate Selection

This selection sets the baud rate. Programming baud rate causes the data to be sent at
the specified rate. The device connected to the auxiliary port must be set up for the same
baud rate as the auxiliary port to ensure reliable communication.
300
600
3-8
Action
Beep (two high tones), illuminate green LED for 2 seconds
Beep (three low tones), illuminate green LED nine times
Illuminate green LED for 135 ms
Illuminate green LED for 2 seconds
Illuminate green LED for 5 seconds
One beep at low volume
One beep at medium volume
One beep at high volume
Beep (one medium tone), illuminate green LED 2 seconds
Beep (three low tones), illuminate green LED nine times