Wand Emulation Selections; Transmission Rate Selection - Intermec Sabre 1552 Scanner System Manual
Scanner and base station
Hide thumbs
Also See for Sabre 1552 Scanner:
- User manual (20 pages) ,
- Supplementary manual (8 pages) ,
- Instructions (2 pages)
Table of Contents
Advertisement
Sabre 1552 Scanner and MicroBar 9745 Base Station System Manual
Wand Emulation Selections
2-14
This section contains programming bar codes for:
•
Transmission Rate Selection
•
Output Polarity Selection
Transmission Rate Selection
This programming selection sets the transmission rate from 10 ips (inches per second)
to 300 ips if the Cordless System is in Wand Emulation mode. Programming the
transmission rate causes the data to be sent at the specified rate. The programmed
transmission rate must be compatible with the device receiving the bar code data.
10
*25
40
80
120
150
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Sabre 1552 Scanner and is the answer not in the manual?