Intermec Sabre 1552 Scanner System Manual page 168

Sabre 1552 Scanner and MicroBar 9745 Base Station System Manual
output delays
default settings, 8-10
selections, 2-13
output polarity, 2-6
configuring, 2-15
default setting, 8-10
with industrial interface, 2-6
P
parity, 2-4, 3-4, 3-9, 8-11
pitch angle, 8-3
pitch, setting beep, 4-6
plug and play selections, 2-4–2-6
port communications
auxiliary, 3-8–3-14
default settings, 8-11
host, 3-3–3-8
power
connector, specifications, 8-8
consumption
base station, 8-5
scanner, 8-3
settings
configuring, 2-16–2-17
defaults, 8-10
prefix
adding, 4-10, 4-13
adding a prefix to UPC and a suffix to all
symbologies, 4-12
AIM ID, 4-8
aux prefix selections, 3-14–3-18
clearing a specific prefix, 4-12
clearing all, 4-11, 4-13
clearing one, 4-11, 4-13
Code ID, 4-9
default setting, 8-12
defaulting, 4-13
discarding changes, 4-14
industrial interface, 2-4
saving changes, 4-14
selections, 4-9–4-15
symbology chart, 4-14
print contrast, 8-3
problems reading bar codes, 7-6
Program Terminal Interface bar code, 2-7
programming bar codes
adding
aux suffix, 3-17
auxiliary prefix, 3-16
prefix, 4-13
suffix, 4-13
AIM ID prefix, 4-8
alternate auxiliary formats, 3-24
alternate data formats, 4-21
Automatic Caps Lock, 2-11
I-10
programming bar codes (continued)
Automatic Direct Connect mode, 2-12
aux port ID transmit selection, 3-11
aux prefix and suffix selections, 3-14–3-18
Base Low Power mode, 2-16
base station software revision, showing, 2-19
Battery Conservation mode, 2-17
baud rate, 3-3, 3-8
Block Ack/Nak protocol, 3-11
Caps Lock, 2-10
clearing
all Aux Data Formats, 3-23
all aux prefixes, 3-16
all aux suffixes, 3-17
all data formats, 4-19
all prefixes, 4-13
all suffixes, 4-13
one Aux Data Format, 3-22
one data format, 4-19
one prefix, 4-13
one suffix, 4-13
Codabar
check character, transmitting, 5-4
check character, validating, 5-4
concatenation, 5-5
defaulting, 5-3
maximum message length, 5-4
minimum message length, 5-4
transmitting start/stop characters, 5-3
turning off, 5-3
turning on, 5-3
Code 11
check digits required, 5-13
defaulting settings, 5-13
maximum message length, 5-13
minimum message length, 5-13
turning on, 5-13
Code 128
maximum message length, 5-14
minimum message length, 5-14
turning off, 5-14
turning on, 5-14
Code 2 of 5
defaulting settings, 5-11
maximum message length, 5-12
minimum message length, 5-12
turning off, 5-11
turning on, 5-11
Code 39
appending, 5-7
check character, transmitting, 5-7
check character, validating, 5-7
defaulting settings, 5-6
full ASCII, 5-7
maximum message length, 5-6