Accessories For The Cordless System - Intermec Sabre 1552 Scanner System Manual

1
Getting Started

Accessories for the Cordless System

Contact your local Intermec representative for more information or to order accessories.
Battery Packs
The permanently sealed battery packs contain four rechargeable "AA" cells, plus
circuitry to allow recharging via standard AC power outlets (eliminating cumbersome
and expensive custom charging stations). Each scanner is shipped with one NiMH
battery pack. Order backup batteries or replacement batteries separately.
Belt Holster
The belt holster holds the scanner when not in use. The belt holster consists of a foam
covered wire frame clasped to an adjustable nylon web belt designed to be worn around
the waist.
Charge Strips
To charge more than one battery pack at one time, charge strips are available. The
charge strips are offered in two or six outlet configurations and may be conveniently
wall mounted or set on flat surfaces. The charge strip uses a standard PC (IEC 320)
grounded power cord between the charge strip and the electrical AC outlet.
Note: The power cords must be ordered separately. For more information, contact your
local Intermec representative.
Head Cover
The head cover features a "D" ring to attach to a tool balancer to suspend the scanner
rather than putting it down.
Visual Menu™
Visual Menu is a software configuration tool that provides the ability to configure the
Cordless System by connecting the base to the COM port of a PC. Visual Menu allows
you to download firmware upgrades, change programmed parameters, and create and
print programming bar codes.
Wall Mount Kit (Standard or Industrial)
The standard wall mount holder stores the scanner on a vertical surface for convenient
access. The scanner easily slides between two rubberized fingers that hold the scanner
when it is not in use.
Similar to the standard wall mount holder, the rubberized fingers on the industrial wall
mount holder are smaller to maintain a firm grasp on the scanner under jolting and
jarring conditions, such as those expected in fork lift applications.
1-7