Serial Wedge Output Selection; Hardware Flow Control Selection - Intermec Sabre 1552 Scanner System Manual

Sabre 1552 Scanner and MicroBar 9745 Base Station System Manual

Serial Wedge Output Selection

This selection selects the serial output direction required by your application. P1 and P2
are serial wedge designations printed on the serial wedge cable. Usually, one goes to the
host and one goes to the terminal, depending on your specific application and the serial
wedge cable.
To P1
To P1 and P2
To P2
*None (Host Port RS-232)

Hardware Flow Control Selection

This selection turns on hardware flow control that checks for a CTS signal before
sending data. This option is useful when your application supports the CTS signal.
Note: This selection cannot be used with Serial Wedge Output Selection.
On
*Off
3-6