Intermec Sabre 1552 Scanner System Manual page 24

Sabre 1552 Scanner and MicroBar 9745 Base Station System Manual
4. Using the scanner, scan the Association Bar Code (the bar code label on the top of
5. Program your Cordless System to work with your terminal or computer by scanning
6. To determine if your Cordless System is set up correctly, scan one of the sample bar
1-10
the base) to link that scanner to the base. Two quick beeps followed by clicking and
a single beep indicates a "good" association. The scanner is now in communication
with the base.
Cordless
laser
scanner
Note: After association, if the battery pack is removed from the scanner and
replaced, the scanner automatically reassociates to the base if the base has remained
powered up. In this case, the scanner beeps when a charged battery pack is installed
and beeps a second time after full association, about 5 to 10 seconds later.
the Terminal Setup Codes. Use the "Terminal Interface Selections" in Chapter 2 to
scan your Terminal ID.
With Plug and Play programming, you scan only one bar code to program the
Cordless System to work with a designated interface, including any required
prefixes and suffixes.
codes in Appendix A, "Programming Chart and Sample Bar Codes."
Association
bar code
Cordless
base
1552S012.eps