Destination Port; Display Nqa History - HP 6125G Command Reference Manual

Description
Use destination ip to configure a destination IP address for a test operation.
Use undo destination ip to remove the configured destination IP address.
By default, no destination IP address is configured for a test operation.
Examples
# Configure the destination IP address of an ICMP echo test operation as 10.1.1.1.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] destination ip 10.1.1.1

destination port

Syntax
destination port port-number
undo destination port
View
TCP, UDP echo, UDP jitter, voice operation view
Default level
2: System level
Parameters
port-number: Specifies the destination port number of a test operation, in the range of 1 to 65535.
Description
Use destination port to configure a destination port number for a test operation.
Use undo destination port to remove the configured destination port number.
By default, no destination port number is configured for a test operation.
Do not perform a UDP jitter test and a voice test on ports from 1 to 1023 (known ports). Otherwise, the
NQA test fails or the corresponding services of this port are unavailable.
Examples
# Configure the destination port number of a test operation as 9000.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type udp-echo
[Sysname-nqa-admin-test-udp-echo] destination port 9000

display nqa history

Syntax
display nqa history [ admin-name operation-tag ] [ | { begin | exclude | include } regular-expression ]
View
Any view
116