Sflow Collector - HP 6125G Command Reference Manual

View
System view
Default level
2: System level
Parameters
ip ip-address: Specifies the IPv4 address of the sFlow agent.
ipv6 ipv6-address: Specifies the IPv6 address of the sFlow agent.
Description
Use sflow agent to configure the IP address of the sFlow agent.
Use undo sflow agent to remove the configured IP address.
By default, no IP address is configured for the sFlow agent. The device periodically checks the existence
of sFlow agent address. If the sFlow agent has no IP address configured, the device automatically selects
an interface IP address for the sFlow agent but does not save the selected IP address.
NOTE:
HP recommends that you configure an IP address manually for the sFlow agent.
•
Only one IP address can be specified for the sFlow agent on the switch.
•
Examples
# Configure the IP address of the sFlow agent.
<Sysname> system-view
[Sysname] sflow agent ip 10.10.10.1

sflow collector

Syntax
sflow collector collector-id { { ip ip-address | ipv6 ipv6-address } | datagram-size size | description text
| port port-number | time-out seconds } *
undo sflow collector collector-id
View
System view
Default level
2: System level
Parameters
collector-id: Specifies the ID of the sFlow collector. The switch can support ten sFlow collectors.
ip ip-address: Specifies the IPv4 address of the sFlow collector.
ipv6 ipv6-address: Specifies the IPv6 address of the sFlow collector.
description text: Specifies a description for the sFlow collector. The default description is "CLI Collector."
datagram-size size: Specifies the maximum length of the sFlow data portion in every sFlow packet that
is sent out. The value ranges from 200 to 3000 bytes and defaults to 1400 bytes.
170