Source Interface - HP 6125G Command Reference Manual

Description
Use route-option bypass-route to enable the routing table bypass function to test the direct connectivity
to the direct destination.
Use undo route-option bypass-route to disable the routing table bypass function.
By default, the routing table bypass function is disabled.
When the routing table bypass function is enabled, the routing table is not searched, and the packet is
sent directly to the destination in a directly connected network.
Examples
# Enable the routing table bypass function.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] route-option bypass-route

source interface

Syntax
source interface interface-type interface-number
undo source interface
View
ICMP echo operation view
Default level
2: System level
Parameters
interface-type interface-number: Specifies an interface by its type and number.
Description
Use source interface to configure the source interface for ICMP echo request packets. The ICMP echo
request packets take the IP address of the source interface as their source IP address. The specified source
interface must be up. Otherwise, no ICMP echo requests can be sent out.
Use undo source interface to restore the default.
By default, no source interface is configured for ICMP echo request packets.
If you configure both the source interface command and the source ip command, the source ip command
takes effect.
Related commands: source ip.
Examples
# Specify the IP address of interface VLAN-interface 2 as the source IP address of ICMP echo request
packets.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] source interface vlan-interface 2
156