Display Ipc Queue - HP 6125G Command Reference Manual

------------------------------------------------------------
1
Statistics for packets acknowledged:
Peak
------------------------------------------------------------
1
Table 44 Command output
Field
Peak
10Sec
1Min
5Min
Total-Data

display ipc queue

Syntax
display ipc queue { node node-id | self-node } [ | { begin | exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
node node-id: Displays sending queue information for the specified node, where node-id represents the
number of the specified node. The value is in the range of 0 to 4.
self-node: Displays sending queue information for the local node.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Description
Use display ipc queue to display sending queue information for the specified node.
Examples
# Display sending queue information for the local node.
<Sysname> display ipc queue self-node
QueueType
1 1
10Sec 1Min
1 1
Description
Peak rate in pps (average rate is measured every 10 seconds, the greatest
value of which is taken as the peak rate).
Average rate (in pps) for the past 10 seconds.
Average rate (in pps) for the past 1 minute.
Average rate (in pps) for the past 5 minutes.
Total amount of data collected from the time when IPC performance statistics
was enabled to the time when this command was executed.
QueueID Dst-NodeID
0
5Min Total-Data
0
Length FullTimes
182
82
78
Packet