Reaction Checked-Element Mos - HP 6125G Command Reference Manual

entry is set to over-threshold. Otherwise, the state is set to below-threshold. Once state of the reaction
entry changes, a trap message is generated and sent to the network management server.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type udp-jitter
[Sysname-nqa-admin-test-udp-jitter] reaction 1 checked-element jitter-ds threshold-type
average threshold-value 50 5 action-type trap-only
# Create reaction entry 2 for monitoring the destination-to-source delay jitter of UDP jitter probe packets.
Set the upper threshold to 50 milliseconds, and the lower threshold to 5 milliseconds. Before the NQA
test group starts, the initial state of the reaction entry is invalid. After each test, the destination-to-source
delay jitter is checked against the threshold range. If the total number of threshold violations exceeds 100
(included), the state of the entry is set to over-threshold. Otherwise, the state of the entry is set to
below-threshold. Once the state of the reaction entry changes, a trap message is generated and sent to
the network management server.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type udp-jitter
[Sysname-nqa-admin-test-udp-jitter] reaction 2 checked-element jitter-ds threshold-type
accumulate 100 threshold-value 50 5 action-type trap-only

reaction checked-element mos

Syntax
reaction item-number
[ action-type { none | trap-only } ]
undo reaction item-number
View
Voice operation view
Default level
2: System level
Parameters
item-number: Specifies a reaction entry ID, in the range of 1 to 10.
threshold-value: Specifies threshold values.
upper-threshold: Specifies an upper threshold, in the range of 1 to 500.
lower-threshold: Specifies a lower threshold, in the range of 1 to 500. It must not be greater than the
upper threshold.
action-type: Specifies what action to be triggered to react to certain measurement conditions and it
defaults to none.
none: Specifies to only record events for terminal display, and not to send any trap messages.
trap-only: Specifies to record events and send SNMP trap messages.
Description
Use reaction checked-element mos to configure a reaction entry for monitoring the MOS value in each
voice test of an NQA operation. You cannot edit a reaction entry. To change the attributes in a reaction
entry, use undo reaction to delete this entire entry and start over.
checked-element mos
146
threshold-value upper-threshold lower-threshold