Probe Timeout - HP 6125G Command Reference Manual

Description
Use probe packet-timeout to configure the timeout time for waiting for a response in a UDP jitter or voice
test.
Use undo probe packet-timeout to restore the default.
By default, the timeout time in a UDP jitter test is 3000 milliseconds, the timeout time in a voice test is
5000 milliseconds.
Examples
# Configure the timeout time for waiting for a response in a UDP jitter test as 100 milliseconds.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type udp-jitter
[Syaname-nqa-admin-test-udp-jitter] probe packet-timeout 100

probe timeout

Syntax
probe timeout timeout
undo probe timeout
View
DHCP, DNS, DLSw, FTP, HTTP, ICMP echo, SNMP, TCP, UDP echo operation view
Default level
2: System level
Parameters
timeout: Specifies the timeout time in milliseconds for a probe operation. The value is in the range of 10
to 86400000 for an FTP or HTTP probe operation, and 10 to 3600000 for a DHCP, DNS, DLSw, ICMP
echo, SNMP, TCP, or UDP echo probe operation.
Description
Use probe timeout to configure the timeout time for a probe operation. When a probe operation does
not complete within the period, the probe operation is timed out.
Use undo probe timeout to restore the default.
By default, the timeout time is 3000 milliseconds for a probe operation.
This command is not supported by UDP jitter or voice tests.
Examples
# Configure the timeout time for a DHCP probe operation as 10000 milliseconds.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type dhcp
[Syaname-nqa-admin-test-dhcp] probe timeout 10000
143