Ntp-Service Dscp - HP 6125G Command Reference Manual

undo ntp-service broadcast-server
View
VLAN interface view
Default level
3: Manage level
Parameters
authentication-keyid keyid: Specifies the key ID to be used for sending broadcast messages to broadcast
clients, where keyid ranges from 1 to 4294967295. This parameter is not meaningful if authentication is
not required.
version number: Specifies the NTP version, where number ranges from 1 to 4 and defaults to 3.
Description
Use ntp-service broadcast-server to configure the device to operate in NTP broadcast server mode and
use the current interface to send NTP broadcast packets.
Use undo ntp-service broadcast-server to remove the configuration.
By default, the device does not operate in any NTP operation mode.
Examples
# Configure the device to operate in broadcast server mode and send NTP broadcast messages on
VLAN-interface 1, using key 4 for encryption, and set the NTP version to 3.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] ntp-service broadcast-server authentication-keyid 4 version 3

ntp-service dscp

Syntax
ntp-service dscp dscp-value
undo ntp-service dscp
View
System view
Default level
2: System level
Parameters
dscp-value: Specifies the Differentiated Services Code Point (DSCP) value for NTP messages, in the range
of 0 to 63.
Description
Use the ntp-service dscp command to set the DSCP value for NTP messages.
Use the undo ntp-service dscp command to restore the default.
By default, the DSCP value for NTP messages is 16.
Examples
# Set the DSCP value to 30 for NTP messages.
22