Display Debugging - HP 6125G Command Reference Manual

By default, debugging functions of all modules are disabled.
Output of the debugging information may degrade system efficiency, so you should enable the
debugging of the corresponding module for diagnosing network failure, and not to enable debugging
of multiple modules at the same time.
Default level describes the default level of the debugging all command. Different debugging commands
may have different default levels.
Configure the debugging, terminal debugging and terminal monitor commands first to display detailed
debugging information on the terminal. For more information about the terminal debugging and
terminal monitor commands, see "Information center commands."
Related commands: display debugging.
Examples
# Enable IP packet debugging.
<Sysname> debugging ip packet

display debugging

Syntax
display debugging [ interface interface-type interface-number ] [ module-name ] [ | { begin | exclude |
include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
interface interface-type interface-number: Displays the debugging settings of the specified interface,
where the interface-type interface-number argument represents the interface type and number.
module-name: Module name.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Description
Use display debugging to display enabled debugging functions.
Related commands: debugging.
Examples
# Display all enabled debugging functions.
<Sysname> display debugging
IP packet debugging is on
11