Use undo snmp-agent log to restore the default.
By default, SNMP logging is disabled.
Use SNMP logging to record the SNMP operations performed on the SNMP agent for auditing NMS
behaviors. The SNMP agent sends log data to the information center. You can configure the information
center to output the data to a specific destination as needed.
Examples
# Enable logging SNMP GET operations.
<Sysname> system-view
[Sysname] snmp-agent log get-operation
# Enable logging SNMP SET operations.
<Sysname> system-view
[Sysname] snmp-agent log set-operation
snmp-agent ifmib long-ifindex enable
Syntax
snmp-agent ifmib long-ifindex enable
undo snmp-agent ifmib long-ifindex enable
View
System view
Default level
2: System level
Parameters
None
Description
Use snmp-agent ifmib long-ifindex enable to switch the format of an NM-specific ifindex from 16-bit to
32-bit.
Use undo snmp-agent ifmib long-ifindex enable to restore the default.
By default, an NM-specific ifindex is in 16-bit format.
Some configurations use parameters relating to NM-specific ifindex; therefore, the switch of NM-specific
ifindex causes temporary ineffectiveness of these configurations (if the format of the ifindex is switched
back, the configurations will become effective again). In this case, you need to perform the
configurations again with the new NM-specific ifindexes, and then the related configurations become
effective. For example, in the configuration of RMON alarm group and private alarm group, the alarm
variables are presented in the format of OID/variable-name.NM-specific-ifindex; the switching of
NM-specific ifindex format makes the RMON alarm variables ineffective. To monitor the affected nodes
again, you need to re-configure the alarm groups with the new format of NM-specific ifindexes.
Examples
# Switch the format of an NM-specific ifindex from 16-bit to 32-bit.
<Sysname> system-view
[Sysname] snmp-agent ifmib long-ifindex enable
71