Parameters
ip-address: Specifies the IP address specified for the UDP listening service on the NQA server.
port-number: Specifies the port number specified for the UDP listening service on the NQA server, in the
range of 1 to 50000.
Description
Use nqa server udp-echo to create a UDP listening service on the NQA server.
Use undo nqa server udp-echo to remove the UDP listening service created.
Configure the command on the NQA server for UDP jitter, UDP echo and voice tests only.
The IP address and port number must be consistent with those configured on the NQA client and must be
different from those of an existing listening service.
The IP address must be that of an interface on the NQA server. Otherwise, the configuration becomes
invalid.
Related commands: nqa server enable and display nqa server status.
Examples
# Create a UDP listening service by using the IP address 169.254.10.2 and port 9000.
<Sysname> system-view
[Sysname] nqa server udp-echo 169.254.10.2 9000
nqa server udp-echo tos
Syntax
nqa server udp-echo tos tos
undo nqa server udp-echo tos
View
System level
Default level
2: System level
Parameters
tos: Specifies the value of the ToS field, in the range of 0 to 255.
Description
Use nqa server udp-echo tos to configure the ToS value in the packets sent by the UDP listening service
on the NQA server.
Use undo nqa server udp-echo tos to restore the default value.
By default, the ToS value is 0.
Examples
# Set the ToS value to 30 in the packets sent by the UDP listening service enabled on the NQA server.
<Sysname> system-view
[Sysname] nqa server udp-echo tos 30
167