Info-Center Loghost - HP 6125G Command Reference Manual

Examples
# Output system information to the log buffer through channel 4, and set the log buffer size to 50.
<Sysname> system-view
[Sysname] info-center logbuffer size 50

info-center loghost

Syntax
info-center loghost [ vpn-instance vpn-instance-name ] { host-ipv4-address | ipv6 host-ipv6-address }
[ port port-number ] [ dscp dscp-value ] [ channel { channel-number | channel-name } | facility
local-number ] *
undo info-center loghost [ vpn-instance vpn-instance-name ] { host-ipv4-address | ipv6
host-ipv6-address }
View
System view
Default level
2: System level
Parameters
vpn-instance vpn-instance-name: Specifies an MPLS L3VPN by its name, a case-sensitive string of 1 to 31
characters. If the log host is on the public network, do not specify this option.
ipv6 host-ipv6-address: Specifies the IPv6 address of a log host.
host-ipv4-address: Specifies the IPv4 address of a log host.
port port-number: Specifies the port number of the log host, in the range of 1 to 65535. The default value
is 514. It must be the same as the value configured on the log host. Otherwise, the log host cannot receive
system information.
dscp dscp-value: Specifies the DSCP value for the packets sent to the log host, in the range of 0 to 63. The
default value is 0.
channel: Specifies the channel through which system information is output to the log host.
channel-number: Specifies a channel number, in the range of 0 to 9.
channel-name: Specifies a channel name, a default name or a self-defined name. For how to configure
a channel name, see the info-center channel name command.
facility local-number: Specifies a logging facility from local0 to local7 for the log host. The default value
is local7. Logging facilities are used to mark different logging sources, and query and filer logs.
Description
Use info-center loghost to specify a log host and configure output parameters.
Use undo info-center loghost to restore the default.
By default, no log host is specified.
If you configure this command without specifying a channel, the system specifies channel 2 (loghost) by
default.
The info-center loghost command takes effect only when the information center has been enabled with
the info-center enable command.
40