Upgrade Ipv6; Configuration Example For Upgrading The System Software Image At The Cli - HP 1910 User Manual

upgrade ipv6

Syntax
upgrade ipv6 server-address source-filename { bootrom | poe | runtime }
Parameters
server-address: Specifies a TFTP server by its IPv6 address.
source-filename: Software package name on the TFTP server.
bootrom: Specifies the Boot ROM image to be upgraded.
poe: Specifies the PoE software to be upgraded.
runtime: Specifies the system software image to be upgraded.
Description
Use upgrade ipv6 server-address source-filename bootrom to upgrade the Boot ROM image. If the Boot
ROM image in the downloaded software package file is not applicable, the original Boot ROM image
is used.
Use upgrade server-address source-filename poe to upgrade the PoE software.
Use upgrade ipv6 server-address source-filename runtime to upgrade the system software image file. If
the system software image file in the downloaded software package file is not applicable, the original
system software image file is used.
To validate the downloaded software package file, reboot the device.
NOTE:
The HP 1910 Switch Series does not provide an independent Boot ROM image. It integrates the Boot ROM
image with the system software image file together in a software package file with the extension name
of .bin.
Examples
# Download software package file main.bin from the TFTP server to upgrade the Boot ROM image.
<Sysname> upgrade ipv6 2001::2 main.bin bootrom
# Download software package file poe.bin from the TFTP server to upgrade the PoE software.
<Sysname> upgrade ipv6 2001::2 poe.bin poe
# Download software package file main.bin from the TFTP server to upgrade the system software image.
<Sysname> upgrade ipv6 2001::2 main.bin runtime
Configuration example for upgrading the system
software image at the CLI
Network requirements
As shown in
to the gateway through GigabitEthernet 1/0/1. The IP address of the gateway is 192.168.1.1/24, and
that of the TFTP server where the system software image (suppose its name is Switch1910.bin) is located
is 192.168.10.1/24. The gateway and the switch can reach each other.
Figure 23, a 1910 switch is connected to the PC through the console cable, and connected
35