Figure 33 Network diagram
Stack
Eth1/0/1
Switch C:
Configuration procedure
1.
Configure global stack parameters on Switch A:
a.
Select Stack from the navigation tree of Switch A to enter the page of the Setup tab, and then
perform the following configurations, as shown in
b.
Type 192.168.1.1 in the field of Private Net IP.
c.
Type 255.255.255.0 in the field of Mask.
d.
Select Enable from the Build Stack list.
e.
Click Apply.
Switch A: Master device
Eth1/0/1
Eth1/0/2
Eth1/0/1
Eth1/0/3
Switch B:
Slave device
Slave device
Eth1/0/1
Switch D: Slave device
Figure
47
34.