Configuration Guidelines - HP 1910 User Manual

Figure 200 Creating dynamic link aggregation group 1

Configuration guidelines

When you configure a link aggregation group, follow these guidelines:
In an aggregation group, t a Selected port must have the same port attributes and class-two
•
configurations as the reference port. To keep these configurations consistent, you should configure
the port manually.
Choose a reference port from the member ports that are in up state and with the same class-two
•
configurations as the aggregate interface. The candidate ports are sorted in the following order:
Full duplex/high speed
Full duplex/low speed
Half duplex/high speed
Half duplex/low speed
If two ports with the same duplex mode/speed pair are present, the one with the lower port
number is chosen.
Port attribute configuration includes the configuration of the port rate, duplex mode, and link state.
•
For more information about class-two configurations, see
• To guarantee a successful static aggregation, make sure that the ports at the two ends of each link
to be aggregated are in the same aggregation state. To guarantee a successful dynamic
"Configuration
228
classes."