HP 1910 User Manual page 429

Figure 395 Network diagram
Configuration prerequisites
Make sure the IP address of the access device added on the portal server is the IP address of the interface
connected to the host (2.2.2.1 in this example), and the IP address group associated with the access
device is the subnet where the host resides (2.2.2.0/24 in this example).
Configure IP addresses for the host, switch, and servers as shown in
reach each other.
Make sure the RADIUS server is correctly configured to provide authentication and accounting functions.
Configuring the switch
1. Configure the RADIUS authentication server:
a. Select Authentication > RADIUS from the navigation tree.
The RADIUS server configuration page appears, as shown in
b. Select Authentication Server as the server type, enter the IP address 192.168.0.112 and port
number 1812, select active from the Primary Server Status list, and click Apply.
Figure 396 Configuring the RADIUS authentication server
2. Configure a RADIUS accounting server:
416
Figure 395 and make sure they can
Figure 396.