Configuring Gts On A Port - HP 1910 User Manual

Table 153 Configuration items
Item
WRR
Setup
Please select port(s)

Configuring GTS on a port

1. Select QoS > GTS from the navigation tree.
2. Click the Setup tab to enter the GTS configuration page.
Figure 491 Configuring GTS on a port
3. Configure GTS on a port as described in
Click Apply.
4.
Table 154 Configuration items
Item
GTS
Description
Enable or disable the WRR queue scheduling mechanism on selected ports. The
following options are available:
WRR
•
Enable—Enables WRR on selected ports.
•
Not Set—Restores the default queuing algorithm on selected ports.
Select the queue to be configured.
Queue
A queue ID is in the range of 0 to 3.
Specify the group the current queue is to be assigned to.
This list is available after you select a queue ID. The following groups are
available for selection:
Group
•
SP—Assigns a queue to the SP group.
•
1—Assigns a queue to WRR group 1.
•
2—Assigns a queue to WRR group 2.
Set a weight for the current queue.
Weight
This list is available when group 1 or group 2 is selected.
Click to select ports to be configured with queuing on the chassis front panel.
Description
Enable or disable GTS on the port.
Table 154.
513