Ipv6 Static Route Configuration Example; Network Requirements; Configuration Considerations; Configuration Procedure - HP 1910 User Manual

IPv6 static route configuration example

Network requirements

As shown in
hosts to communicate with each other.
Figure 276 Network diagram
Host A
1::2/64

Configuration considerations

On Switch A, configure a default route with Switch B as the next hop.
On Switch B, configure one static route with Switch A as the next hop and the other with Switch C as the
next hop.
On Switch C, configure a default route with Switch B as the next hop.

Configuration procedure

1. Configure a default route to Switch B on Switch A:
a. Select Network > IPv6 Routing from the navigation tree of Switch A.
b. Click the Create tab.
c. Enter :: for Destination IP Address, select 0 from the Prefix Length list, and enter 4::2 for Next
Hop.
d. Click Apply.
Figure 276, configure IPv6 static routes on Switch A, Switch B, and Switch C for any two
Vlan-int200
4::2/64
Vlan-int200
4::1/64
Vlan-int100
1::1/64
Switch A
Host B
2::2/64
Vlan-int400
2::1/64
Vlan-int300
5::2/64
Switch B
Vlan-int300
5::1/64
Vlan-int500
3::1/64
Switch C
310
Host C
3::2/64