4.
Click Apply.
Table 51 Configuration items
Item
OUI Address
Mask
Description
Voice VLAN configuration examples
Configuring voice VLAN on a port in automatic voice VLAN
assignment mode
Network requirements
As shown in
Configure VLAN 2 as the voice VLAN allowing only voice traffic to pass through.
•
The IP phone connected to hybrid port GigabitEthernet 1/0/1 sends untagged voice traffic.
•
GigabitEthernet 1/0/1 operates in automatic VLAN assignment mode. Set the voice VLAN aging
•
timer to 30 minutes.
•
Configure GigabitEthernet 1/0/1 to allow voice packets whose source MAC addresses match the
OUI addresses specified by OUI address 001 1-2200-0000 and mask ffff-ff00-0000. The
description of the OUI address entry is test.
Figure 158 Network diagram
Configuring Switch A
1.
Create VLAN 2:
a.
Select Network > VLAN from the navigation tree.
b.
Click the Create tab.
c.
Enter VLAN ID 2.
d.
Click Create.
Description
Set the source MAC address of voice traffic.
Set the mask length of the source MAC address.
Set the description of the OUI address entry.
Figure
158:
175