HP 1910 User Manual page 415

Figure 376 Applying a portal server to a Layer 3 interface
3. Configure Layer 3 portal authentication as described in
4. Click Apply.
Table 111 Configuration items
Item Description
Interface Select the Layer 3 interface to be enabled with portal authentication.
Select the portal server to be applied on the selected interface. Options include:
•
•
Portal Server
•
Specify the portal authentication mode:
•
•
Method
Cross-subnet portal authentication mode does not require Layer 3 forwarding devices to be
present between the authentication client and the access device. However, if there are Layer
3 forwarding devices between the authentication client and the access device, you must
select the cross-subnet portal authentication mode.
Select Server—Select an existing portal server from the portal server drop-down list.
New Server—If you select this option from the drop-down list, the portal server
configuration area (see Figure
You can add a remote portal server and apply the portal server to the Layer 3
interface. For configuration details, see
Enable Local Server—If you select this option from the drop-down list, the local portal
service configuration area (see
page. You can configure the parameters for the Layer 3 local portal service. For
configuration details, see
Direct—Direct portal authentication.
Layer3—Cross-subnet portal authentication.
IMPORTANT:
402
Table 111.
377) will be displayed at the lower part of the page.
Table 1 12.
Figure 378) will be displayed at the lower part of the
Table 1 13.