HP 1910 User Manual page 156

6. Configure a target host SNMP traps:
a. Click Add on the Trap tab page.
The page for adding a target host of SNMP traps appears.
b. Type 1.1.1.2 in the following field, type user1 in the Security Name field, select v3 from the
Security Model list, and select Auth/Priv from the Security Level list.
c. Click Apply.
Figure 134 Adding a trap target host
Configuring the NMS
To avoid communication failures, make sure the NMS use the same SNMP settings as the agent.
To configure the NMS:
1. Specify the SNMP version for the NMS as v3.
2. Create an SNMP user user1.
3. Enable both authentication and privacy functions
4. Use MD5 for authentication and DES56 for encryption.
5. Set the authentication key to authkey and the privacy key to prikey.
For information about configuring the NMS, see the NMS manual.
Verifying the configuration
After the above configuration, the NMS can establish an SNMP connection with the agent and query
and reconfigure values of objects in the agent MIB.
Disable or enable an idle interface on the agent, and you can see the interface state change traps on the
NMS.
143