Print Parameters Menu - Oce Arizona T220 User Manual

Print Parameters
This menu lets you determine whether the Pre-Fire Stripe, which fires all heads at
the beginning of each swath during printing, is active. If the Pre-fire Stripe is ON
you can determine if it fires on the pre-fire strpe catcher or on the edge of the media
closest to the capping station. Stripe2 gives you the option of printing a second
prefire stripe on the far side of the media or the Diagnostic Strip. See "The Pre-Fire
Stripe" on page 45 for more information.
The Print Parameters menu also lets you set Enable Job Parameter Changes. If this
is set to ON, you can decide which of the following options are presented to the
operator prior to printing (See "Print Job Parameter Options" on page 32):
Follow these steps to use the Print Parameters menus:
Barcode
Allows you to scan barcodes for new bottles of ink using the barcode wand. Barcodes
can also be entered manually using the keypad (See "Scanning Ink Barcodes" on
page 55).
10/16/03
• BiDirectional Printing - either in both directions or just right to left
• Drying Delay Home - pauses the carriage before each swath
• # of Copies - print up to 100 copies of an image
• # of Overprints - prints the image on the media up to 3 times
Figure 6 Print Parameters Menu
1. Press the MENU button twice at the online screen.
2. Press the ACCEPT button at MAIN MENU operator. You then see:
OPERATOR maintenance
3. Press MENU twice then ACCEPT to access the Print Parameters menu.
Menu Structure |
2-21