Load A Take-Up Roll Core Onto The Roll Winder - Oce Colorado 1640 Operation Manual

Load a take-up roll core onto the roll winder

Introduction
When you want to wind media, you must load a take-up roll core onto the roll winder first.
IMPORTANT
Make sure you use the core of an empty media roll with the same width or wider as the media
you are printing on.
Procedure
1. Locate the winder on the media output side.
2. Push the green levers on both sides of the take-up media shaft. Remove the take-up media shaft
from the winder.
1
2
Load a take-up roll core onto the roll winder
Chapter 3 - Handle the media 61