Installing The Cable Management Frames - Cisco Nexus 7000 Series Hardware Installation And Reference Manual

Chapter 2 Installing a Cisco Nexus 7009 Chassis

Installing the Cable Management Frames

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Installing the Cable Management Frames
After you have fully installed the Cisco Nexus 7009 switch chassis in the rack or cabinet (see the
"Installing the Chassis" section on page 2-11), you can install the cable management frames on the front
of the chassis.
When you install the cable management frames, you attach two side frames to the front-mount brackets
on the chassis and then attach a top hood to the top of the two side frames and the chassis.
Chassis with center-mount brackets include front-mount brackets for holding the cable management
Note
frames.
To install the cable management frames on the Cisco Nexus 7009 switch chassis, follow these steps:
Attach a cable management frame (part number 800-33786) onto the two hooks that protrude from the
Step 1
lower half of the left front-mount bracket that is attached to the Cisco Nexus 7009 switch chassis, and
loosely fasten the frame to the chassis with four flat-head M4x10 screws as shown in Figure 2-14.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
2-24
OL-23069-06