Defining And Configuring Lwapp Ap Groups For Cisco Devices; Viewing And Creating Ap Groups - Dell PowerConnect W-Airwave User Manual

Figure 55 Groups > Cisco WLC Config > WLANs > Add New SSID/VLAN > Advanced Tab Illustration

Defining and Configuring LWAPP AP Groups for Cisco Devices

The Groups > Cisco WLC Config > WLANs > Advanced > AP Groups page allows the user to add/edit/delete
AP Groups on the Cisco WLC. LWAPP AP Groups are used to limit the WLANs available on each AP. Cisco
thin APs are assigned to LWAPP AP Groups.

Viewing and Creating AP Groups

1. Navigate to the Groups > Cisco WLC Config page, and click WLANs > Advanced > AP Groups in the
navigation pane at left. This page displays the configured LWAPP APs.
Figure 56 Groups > Cisco WLC Config > WLANS > Advanced > AP Groups Page Illustration
2. To add a new LWAPP AP group, click Yes in the AP Groups section. Additional controls appear.
3. Click the Add button to create a new LWAPP AP group. To edit an existing LWAPP AP group, click the
pencil icon next to that group. Add one or more SSIDs and the interface/VLAN ID mapping on the Add/Edit
page of the LWAPP AP Group.
4. Click Save and Apply to push these settings to the Cisco WLC controllers immediately, or click Save to retain
these changes to be pushed to controllers at a later time.
Dell PowerConnect W AirWave 7.1 | User Guide
Figure 56 illustrates this page.
Configuring and Using Device Groups in AWMS | 109