Rapids Setup; Basic Configuration - Dell PowerConnect W-Airwave User Manual

Note: Be aware that not all rogue discovery methods will have all information required for resolution. For example, the switch/
router information, port, or IP address are found only through switch or router polling. Furthermore, RSSI, signal, channel, SSID,
WEP, or network type information only appear through wireless scanning. Such information can vary according to the device type
that performs the scan.

RAPIDS Setup

The RAPIDS > Setup page allows you to configure your AMP server for RAPIDS. Complete the settings on this
page as desired, and click Save. Note that most of the settings are internal to how AMP will process rogues.

Basic Configuration

On the RAPIDS > Setup page, the Basic Configuration section allows you to define RAPIDS behavior settings.
Table 99
Table 99 RAPIDS > Setup Page Illustration
Table 100 RAPIDS > Setup> Classification Options
Field
Acknowledge Rogues by
Default
Manually Classifying Rogues
Automatically Acknowledges
them
Table 101 RAPIDS > Setup > Filtering Options
Field
Filter ad-hoc rogues
202 | Using RAPIDS and Rogue Classification
illustrates this page.
Default
No
Yes
Default
No
Description
Sets RAPIDS to acknowledge rogue devices upon initial detection, prior to
their classification.
Defines whether acknowledgement happens automatically whenever a rogue
device receives a manual classification.
Description
Filters rogues according to ad-hoc status.
Dell PowerConnect W AirWave 7.1 | User Guide