Determining The Boot-Block Version; Resetting The Ap (For Boot-Block Versions From 1.02 To 11.06); Resetting The Ap (For Boot-Block Versions 11.07 And Higher) - Dell PowerConnect W-Airwave User Manual

Determining the Boot-Block Version

The subsequent steps that you must follow to reset the Cisco AP depend on the version of the AP's boot-block.
Follow the steps below to determine which boot-block version is currently on your AP, then use the
corresponding instructions detailed below.
When you connect to the AP, the Summary Status screen appears. Reboot the AP by pressing CTRL-X or by
unplugging and then re-plugging the power connector. As the AP reboots, introductory system information will
appear onscreen.
The boot-block version appears in the third line of this text and is labeled Bootstrap Ver.
System ID: 00409625854D
Motherboard: MPC860 50MHz, 2048KB FLASH, 16384KB DRAM, Revision 20
Bootstrap Ver. 1.01: FLASH, CRC 4143E410 (OK)
Initialization: OK

Resetting the AP (for Boot-Block Versions from 1.02 to 11.06)

Follow these steps to reset your AP if the boot-block version on your AP is greater than or equal to version 1.02
but less than 11.07:
1. If you have not done so already, connect to the AP (see above), click OK, and press Enter.
2. When the Summary Status screen appears, reboot the AP by pressing CTRL-X or by unplugging and then
re-plugging the power connector.
3. When the memory files are listed under the heading Memory: File, press CTRL-W within five seconds to
reach the boot-block menu.
4. Copy the AP's installation key to the AP's DRAM by performing the following steps:
Press C to select Copy File.

Press 1 to select DRAM.

Press the selection letter for AP Installation Key.

5. Perform the following steps to reformat the AP's configuration memory bank:
Press CTRL-Z to reach the Reformat menu.

Press ! (SHIFT-1) to select FORMAT Memory Bank.

Press 2 to select Config.

Press upper-case Y (SHIFT-Y) to confirm the FORMAT command.

Press CTRL-Z to reach the reformat menu and to reformat the AP's configuration memory bank.

6. Copy the installation key back to the configuration memory bank as follows:
Press C to select Copy file

Press 2 to select Config.

Press the selection letter for AP Installation Key.

7. Perform the following steps to run the AP firmware:
Press R to select Run

Select the letter for the firmware file that is displayed.

The following message appears while the AP starts the firmware:
8. When the Express Setup screen appears, begin reconfiguring the AP using the terminal emulator or an
Internet browser.

Resetting the AP (for Boot-Block Versions 11.07 and Higher)

Follow these steps to reset your AP if the boot-block version on your AP is greater than 11.07:
310 | Access Point Notes
Inflating <firmware file name>
Dell PowerConnect W AirWave 7.1 | User Guide
.