Dell PowerConnect W-Airwave User Manual page 87

8. To configure Spanning Tree Protocol on WLSE devices and Proxim APs, locate the Spanning Tree Protocol
section on the Groups > Basic configuration page. Adjust these settings as required.
settings and default values.
Table 42 Spanning Tree Protocol Fields and Default Values
Setting
Spanning Tree
Protocol
Bridge Priority
Bridge Maximum
Age
Bridge Hello Time 2
Bridge Forward
Delay
9. To configure NTP settings locate the NTP section and adjust these settings as required.
the settings and default values.
Table 43 NTP Fields and Default Values
Setting
NTP Server #1,2,3 None
UTC Time Zone
Daylight Saving
Time
10. To configure settings specific to Cisco IOS/VxWorks, locate the Cisco IOS/VxWorks section and adjust these
settings as required.
Table 44 Cisco IOS/VxWorks Fields and Default Values
Setting
Cisco IOS SNMP
Version
Cisco IOS CLI
Communication
Cisco IOS Config File
Communication
Track Usernames on
Cisco Aironet
VxWorks APs
Dell PowerConnect W AirWave 7.1 | User Guide
Default Description
No Enables or disables Spanning Tree Protocol on WLSE devices and Proxim APs.
32768 Sets the priority for the AP. Values range from 0 to 65535. Lower values have higher priority.
The lowest value is the root of the spanning tree. If all devices are at default the device with
the lowest MAC address will become the root.
20 Sets the maximum time, in seconds, that the device stores protocol information. The
supported range is from 6 to 40.
Sets the time, in seconds, between Hello message broadcasts.
15 Sets the time, in seconds, that the port spends in listening and learning mode if the spanning
tree has changed.
Default Description
Sets the IP address of the NTP server that is to be configured on the AP.
0 Sets the hour offset from UTC time to local time for the AP. Times displayed in AWMS graphs
and logs use the time set on the AWMS server.
No Enables or disables the advanced daylight saving time settings in the Proxim and HP
ProCurve 420 sections of the Groups > Basic configuration page.
Table 44 describes the settings and default values.
Default Description
2c Drop-down menu specifies the version of SNMP used by AWMS to communicate to
the AP.
Telnet Sets the protocol AWMS uses to communicate with Cisco IOS devices. Selecting SSH
uses the secure shell for command line page (CLI) communication. Selecting Telnet
sends the data in clear text via Telnet.
TFTP Sets the protocol AWMS uses to communicate with Cisco IOS devices. Selecting SCP
uses the secure copy protocol for file transfers. Selecting TFTP will use the insecure
trivial file transfer protocol. The SCP login and password should be entered in the
Telnet username and password fields.
No Configures VxWorks APs to send SNMP packets to AWMS.
Table 42
Table 43
Configuring and Using Device Groups in AWMS |
describes the
describes
87