Configuring Acs For Wds Authentication; Configuring Cisco Wlse Rogue Scanning - Dell PowerConnect W-Airwave User Manual

2. If the AP is the Primary or Backup WDS, select Use the AP as Wireless Domain Services.
Select Priority (set 200 for Primary, 100 for Secondary).

Configure the Wireless Network Manager (configure the IP address of WLSE).

3. If the AP is Member Only, leave all options unchecked.
4. Navigate to the Security > Server Manager page.
5. Enter the IP address and Shared Secret for the ACS server.
6. Click the Apply button.
7. Navigate to the Wireless Services > WDS > Server Group page.
8. Enter the WDS Group of AP.
9. Select the ACS server in the Priority 1 drop- down menu.
10. Click the Apply button.

Configuring ACS for WDS Authentication

ACS authenticates all components of the WDS and must be configured first. Perform these steps to make this
configuration.
1. Login to the ACS.
2. Navigate to the System Configuration > ACS Certificate Setup page.
3. Install a New Certificate by clicking the Install New Certificate button, or skip to the next step if the
certificate was previously installed.
4. Click the User Setup button in the left frame.
5. Enter the Username that will be used to authenticate into the WDS and click Add/Edit button.
6. Enter the Password that will be used to authenticate into the WDS and click the Submit button.
7. Navigate to the Network Configuration > Add AAA Client page.
8. Add AP Hostname, AP IP Address, and Community String (for the key).
9. Enter the Password that will be used to authenticate into the WDS and click the Submit button.
For additional and more general information about ACS, refer to

Configuring Cisco WLSE Rogue Scanning

The AMP Setup > WLSE page allows AWMS to integrate with the Cisco Wireless LAN Solution Engine
(WLSE). AWMS can discover APs and gather rogue scanning data from the Cisco WLSE.
Figure 33
WLSE.
Figure 33 AMP Setup > WLSE > Add WLSE Page Illustration
Perform the following steps for optional configuration of AWMS for support of Cisco WLSE rogue scanning.
Dell PowerConnect W AirWave 7.1 | User Guide
illustrates and itemizes the AWMS settings for communication that is enabled between AWMS and
"Configuring ACS Servers" on page 71.
Configuring AWMS | 69